If yes, you should use our troubleshooting guide and community support channels, see http://kubernetes.io/docs/troubleshooting/.
If no, delete this section and continue on.
If you have found any duplicates, you should instead reply there and close this page.
If you have not found any duplicates, delete this section and continue on.
Choose one: BUG REPORT or FEATURE REQUEST
kubeadm version (use kubeadm version
): will not load
*Environment
kubectl version
): Client Version: version.Info{Major:"1", Minor:"13", GitVersion:"v1.13.1", GitCommit:"eec55b9ba98609a46fee712359c7b5b365bdd920", GitTreeState:"clean", BuildDate:"2018-12-13T10:39:04Z", GoVersion:"go1.11.2", Compiler:"gc", Platform:"linux/amd64"}uname -a
):sudo snap install kubeadm
error: This revision of snap "kubeadm" was published using classic confinement
and thus may perform arbitrary system changes outside of the security
sandbox that snaps are usually confined to, which may put your system at
risk.
If you understand and want to proceed repeat the command including
--classic.
jbrandes@k8s-master:~$ sudo snap install kubeadm--classic
error: snap "kubeadm--classic" not found
Hi @jbrandes and thank you for filing this issue!
Unfortunately the Kubernetes community does not produce snap packages for any of the components. I think, that those are done by Canonical themselves.
The community recommended way of installing kubeadm is through DEB or RPM packages as described here:
https://kubernetes.io/docs/setup/independent/install-kubeadm/
close as per @rosti 's comment +1
I have to say, Kubernetes documentation for a non-existing user is utterly useless. How can you justify not providing functional installation instructions?
@BestBackwards
The install instructions for kubeadm is located here: https://kubernetes.io/docs/setup/independent/install-kubeadm/
It provides the steps, requirements and exact commands to run on the different supported distributions.
Most helpful comment
Hi @jbrandes and thank you for filing this issue!
Unfortunately the Kubernetes community does not produce snap packages for any of the components. I think, that those are done by Canonical themselves.
The community recommended way of installing kubeadm is through DEB or RPM packages as described here:
https://kubernetes.io/docs/setup/independent/install-kubeadm/