Hello Again
perhaps I'm missing the obvious - if so please forgive me .
I've notices on my sensors that they are only updating every so often on my Domoticz interface. Usually the sensor reading timestamps are hours behind. Is there any way to check/ change the polling frequency on the console? I've gone through the Tasmota commands and can't find any reference to it.
the sensor data is reported every 'teleperiod', by default every 300 seconds.
This can be set to anything down to 10 seconds.
TelePeriod | | Show current telemetry period in seconds
-- | -- | --
TelePeriod | 0 / off | Disable telemetry messages
TelePeriod | 1 | Reset telemetry period to user_config.h (TELE_PERIOD)
TelePeriod |
Thank you very much
Most helpful comment
TelePeriod | | Show current telemetry period in seconds | Set telemetry period between 10 and 3600 seconds
-- | -- | --
TelePeriod | 0 / off | Disable telemetry messages
TelePeriod | 1 | Reset telemetry period to user_config.h (TELE_PERIOD)
TelePeriod |